My Mac doesn't recognize my TV's resolution on (so far) 3 VGA cables I've tried but it works just fine using other seemingly old VGA cables. My roommate had the same experience on Mint Linux.
What's the difference between VGA cables? What should I look for in a VGA cable that I buy? Are those still being made?
Answer
As @Wyzard says, computers talk to monitors via DDC and this uses 4 pins on the vga. See the pinout on wikipedia.
A working vga cable needs all the pins wired independently from each, and also from the cable shielding to the chassis, i.e the metal cover of the plugs and sockets. Only pins 4 and 11 can be missing or not cabled.
Inside a monitor there is a small eprom holding information on the monitor's resolutions (the EDID). This eprom is accessible even when the monitor is powered off, as it is independently powered from the computer by 5 volts on pin 9, with ground on pins 10 and 5. The eprom is read using i2c clock and data signals on pins 12 and 15. These days with DDC, the i2c bus can do other things too.
The analogue video signals on pins 1, 2, 3 have independent analogue ground on 6, 7, and 8.
Some bad vga cables will not have these analogue grounds, nor the i2c ground, and assume the cable shielding will do. This often does not work. The only way to check vga cables is with a continuity tester (multimeter) ensuring that all pins are wired through, and none are in common, including the shield.
No comments:
Post a Comment